USE: Interior Only
COLOR: Slightly pinkish in the the bottle. Dries to an amber tone.
SHEEN: Clear
SANDING: On bare wood sand to 180 grit. For more open grained woods sand to 220 grit.
COATS: Normally 3 (additional coats can be applied)
RECOAT: 30 minutes if brushing on or wiping on, 3-5 minutes if working on the lathe.
CLEANUP: General clean-up with soap and warm water recommended. Rinse thoroughly with clean water. For best results, clean all equipment with General Finishes Brush and Gun Cleaner.
DRY TIME for light use: 7 days. Good ventilation, air movement and higher temperatures will accelerate cure time. Cooler temperatures will slow cure time.
CURE TIME: Light use (7-10 days), Regular use (21 days) under ideal conditions (70 degrees and 70% humidity). Good ventilation, air movement and higher temperatures will accelerate dry time. Cooler temperatures will slow cure time. Cure time is the amount of time needed for the finish on a piece to reach maximum hardness and be ready for normal use. This is different than "dry time." This is different than "dry time." During the curing stage, treat your project with special care. Avoid placing heavy objects on it. Always avoid the use furniture polishes, dusting sprays or oil soaps as they may contaminate the finish for future recoating. Use a water dampened cloth for regular cleaning.
WATER SPILLS AND DAILY USE: Clean water spills up as they occur during regular use and protect from heat. Although General Finishes products are water resistant, they are not impervious to water. Surfaces will not be damaged by spilled water so long as it is cleaned up promptly. We recommend using coasters to protect your wood from standing water and pot holders to protect from heat.
Cleanup: General clean-up with soap and warm water recommended. Rinse thoroughly with clean water. For best results, clean all equipment with General Finishes Brush and Gun Cleaner.
SEALER: Do not use sealers with the Wood Turners Finish, it should be used alone.
BOTTLE SIZES: 8 oz.
COVERAGE: 150 sq.ft/qt
VOC: <275g/l (2.28lbs/gal.)
ADDITIVES: Accelerator performs well when working on a lathe to increase speed of dry time.